Konica Minolta bizhub 601 User Manual page 486

Authentication Unit (Biometric Type AU-101)
15
Click [Finish].
Data Administrator Bio Plugin is installed, and the setup is completed.
Registering users
Reminder
In order to register users with Data Administrator, the authentication unit must be connected to the USB
port of the computer, and the computer and this machine must be connected over a network.
1
If the authentication unit is connected to the machine, turn off the machine with the main power switch,
and then disconnect the authentication unit.
– If the authentication unit is connected to the computer, continue with step 4.
– When the machine is turned off, then on again with the main power switch, wait at least 10 seconds
to turn the machine on after turning it off. The machine may not operate correctly if it is turned on
immediately after being turned off.
– Hold the plug when plugging and unplugging the USB cable, otherwise the cable may be damaged.
2
Turn on the machine with the main power switch.
3
Connect the authentication unit to the USB port of the computer installed with Data Administrator.
– Do not connect other USB devices to the same port where the authentication unit is connected. If
enough USB power is not provided, the authentication unit may not operate correctly.
– When using a USB hub, be sure to use a self-powered USB hub that can provide 500 mA or more.
– After connecting the authentication unit, wait at least 5 seconds before operating it.
751/601
Network
This machine
USB
Authentication unit
Computer
12
12-11