Loading Paper Of A Different Size Into Paper Trays; Changing The Size Of Paper That Is Loaded - Konica Minolta bizhub 601 User Manual

Before Making Copies
1.8

Loading paper of a different size into paper trays

The paper loaded into the tray 3 and 4 can be changed to that of a different size.
Note
To load paper of a different size into the tray 1 and 2 and the LCT, contact your service representative.
1.8.1

Changing the size of paper that is loaded

1
Pull out the tray 3 or 4.
2
Raise the paper take-up roller.
3
Remove the trailing-edge guide, and then insert it at the position for the desired paper size.
– Press the button to remove the trailing-edge guide.
– Insert the trailing-edge guide into the hole
corresponding to the size indicated on the bottom
plate.
4
Load paper of the new size, and then slide the lateral guide to fit the size of the paper.
– Move the lateral guide while holding the release
button pressed. When the button is released, the
guide is locked in place.
5
Fully push in the paper tray.
– If paper other than standard-size paper or thick paper was loaded, specify the settings for the
loaded paper in the Paper Type screen. Refer to
751/601
"Paper type setting for a tray" on page
1
6-20.
1-57