GMC 1976 ZEO 6083 Maintenance Manual page 840

GENERAL INFORMATION
The Motor Home integral vacuum cleaner (op-
tional on Model 260) operates on 120-volt current .
The vehicle must be connected to an external power
source or the motor generator must be in operation
in order to operate the vacuum cleaner.
Vacuum cleaner components are stored in the
side of the refrigerator module near the entrance
door. The vacuum cleaner storage cabinet contains a
long flex hose, wand, and a wide assortment of wand
attachments including one for shag carpeting (See
figure 1) .
To operate the vacuum system, remove flex hose
Figure 1-Vacuum Cleaner Components
SECTION 24Q
OTHER EQUIPMENT
VACUUM CLEANER
OTHER EQUIPMENT
24Q- 1
from the cabinet, lift vacuum inlet hinge cap, just
under the storage cabinet, and insert the proper end
of the flex hose (figure 2) . At this point the vacuum
system will be operating and is used in the same
manner as any household vacuum cleaner.
BAG AND FILTER
REPLACEMENT
The vacuum cleaner contains two filters - the bag
itself which catches the dirt and a secondary filter to
keep any residual dirt out of the motor.
1 . To remove the filled filter bag, slide cardboard
end of bag with rubber seal off intake tube. Pull bag
forward and out of cabinet.
2. To replace filter bag, spread new bag and posi-
tion in cabinet. Slide cardboard end with rubber seal
up over intake tube by starting at back of tube and
pulling forward and up .
3. The secondary filter is located at the top of the
filter bag chamber. The secondary filter should be
removed and cleaned often.
Figure 2-Connecting Flex Hose to Wall Inlet