GMC 1976 ZEO 6083 Maintenance Manual page 761

INSTALLATION
1 . Install sight dial .
2 . Install two dial retaining screws .
3 . Install wire and retainer screw.
GAS TANK FLOAT ASSEMBLY
REMOVAL
1 . Empty tank. Refer to WARNING at begin-
ning of this section .
10).
2. Disconnect wire at sight dial .
3. Remove four float retaining screws (See figure
4. Remove float assembly .
NOTE :
Position float as shown in Figure 10
while removing from tank .
INSTALLATION
1 . Install float assembly .
2. Install and tighten four retaining screws .
3. Connect wire to sight dial .
4. Fill tank .
When filling the tank refer to IMPORTANT at
beginning of this section .
REMOVAL
Figure 1 1-L .P . Gas Lines
LP GAS SYSTEM 24F- 7
LP GAS TANK
1 . Empty tank. Refer to WARNING at begin-
ning of this section.
2. Disconnect hose assembly from regulator and
position out of the way.
3 . Disconnect wire from sight dial .
4. Remove four nuts and bolts securing tank to
vehicle (See figure 8). Ground wire is under one of
these bolts.
5 . Remove tank.
INSTALLATION
1 . Install tank and four bolt and nut assemblies .
Secure ground wire under same bolt.
MAIN GAS HOSE
MAIN GAS LINE A-3361