GMC 1976 ZEO 6083 Maintenance Manual page 784

WARNING : BEFORE PERFORMING ANY RE-
MOVAL OR DISASSEMBLY PROCEDURES, BE
SURE THE LP GAS IS TURNED COMPLETELY
OFF AT THE LP GAS TANK .
NOTE :
To gain space when working in and/or
on range/oven (figure 5) it is often desirable to
remove the oven door .
OVEN DOOR REPLACEMENT
1. Place screwdrivers (awls, nails, etc.) through
holes in oven door hinge while door is open (figure
6) .
Figure 6-Inserting Pin In Door Hinge
3. Remove door .
4. To reinstall reverse procedure.
RANGE/OVEN 24H- 5
RANGE/OVEN COMPONENT DISASSEMBLY
PROCEDURES
2. Lift door (as if to close) and disengage hinges
at door (See figure 7) .
OVEN THERMOSTAT CONTROL
REPLACEMENT
1 . Remove oven door .
2. Remove cook top and grates (See figure 8) .
Figure 7-Disengaging Door Hinge
Problem Possible Cause Correction
Oven burner ignites as
1 . Oven Safety Valve - 1 . Replace Oven Safety Valve.
soon as thermostat con-
If there is not a 45
trol is turned to de- second delay before
sired temperature. oven burner ignites after
the desired oven temper-
ature is set, the Oven
Safety Valve is faulty .