GMC 1976 ZEO 6083 Maintenance Manual page 500

7- 5 2
TRANSMISSION
Figure 69-Air Checking Intermediate Clutch & Piston
support .
9. Lubricate center support to reaction carrier
thrust
washer with petrolatum and install washer in recess
of center support, Figure 70 .
10 . Install center support assembly into roller
clutch in reaction carrier, Figure 71 .
NOTE : With reaction carrier held, center sup-
port should turn clockwise only .
11 . Install Gear Assembly Remover and Installer
Adapter, J-21795, on end of main shaft so that tangs
Figure 70-Center Support to Reaction Carrier Thrust
Washer
Figure 71-Center Support Installation
engauge groove in shaft. Using Slide Hammer Han-
dle, J-6125, and Speedometer Puller Bolt, J-21797,
tighten bolt on tool to secure tool on shaft and pre-
vent movement of the roller clutch during installa-
tion of the gear unit assembly, Figure 47 .
INSTALL REAR BAND AND
COMPLETE GEAR UNIT
ASSEMBLY
1 . Inspect rear band for cracks or distortion and
band ends for damage to anchor lugs and apply lug.
Also inspect lining for cracks, flaking, burning and
looseness.
2. Install rear band assembly in transmission case
so that band lugs index with anchor pins .
3. Inspect support to case spacer for burrs or
raised edges. If present, remove with a stone or fine
sandpaper.
4. Install the support case spacer against the
shoulder at the bottom of case splines and the gap
located adjacent to the band anchor pin, Figure 72 .
CAUTION :
Do not confuse this spacer (.040"
thick and both sides flat) with either the