GMC 1976 ZEO 6083 Maintenance Manual page 758

24F- 4 LP GAS SYSTEM
Figure 3-Hanging Manometer
bracket (J-26264) (figure 3) . Open the two elbows at
top of manometer two turns each so that the fluid
levels are equal, then move scale so that "O" matches
this level (figure 4) .
3. Remove screw holding right hand burner in
place and remove burner (figure 5) . Connect hose
from one manometer elbow to right hand burner
speed (figure 6) . Position hose away from other burn-
ers. Turn one range top burner all the way on, with
gas burning.
Figure 4-Setting Manometer Scale
Figure 5-Removing Burner From Stove
WARNING: MAKE SURE THAT RUBBER HOSE
IS PLACED CAREFULLY AWAY FROM OPERAT-
ING RANGE TOP BURNER .
4. Turn on burner control connected to manome-
ter. Read the high to low difference on the manome-
ter. If the difference is not 11 inches the regulator
needs adjusting. Adjust the regulator until a reading
of 11 .0 inches is obtained . Refer to "Regulator Ad-
justment" . If the reading is outside of an 11 +- 2 inch
range (9 inches to 13 inches), with range/oven and
Figure 6-Manometer Connection to Spud