GMC 1976 ZEO 6083 Maintenance Manual page 342

GENERATOR BELT
Removal
1 . Loosen bolts at generator adjusting arm and
loosen pivot bolt at generator support bracket.
2. Move generator toward engine until belt can be
removed from pulley .
Installation
1 . To install new belt, position belt on pulley and
move generator away from engine until required ten-
sion is measured .
2. Tighten generator adjusting arm bolts and pi-
vot bolt to specified torque (figure 12).
NOTE : Removal and installation of air condi-
tioning compressor belt is accomplished in the
ENGINE COOLING 6K- 1 1
Figure 13-Air Conditioning Compressor Mounting
same manner as described above. Refer to Fig-
ure 13 for specified torque of compressor mount-
ing bolts.