GMC 1976 ZEO 6083 Maintenance Manual page 25

1- 8 BODY
Installation
Figure 7-Removing Sash Banding Strap
4. Clean glass sash channels thoroughly .
1 . Install glass into sash .
2. Referring to Figure 7 and 8, assemble sash.
3. Install sash assembly . Refer to "Sash Assem-
bly-Installation" earlier in this section.
Figure 8-Disassembling Sash
SIDE WINDOW LATCH
Removal
1 . Remove two (2) screws attaching latch to
glass.
2. Remove two (2) threaded plastic buttons.
3 . Remove latch.
Installation
1 . Install a new seal to latch.
2. Install latch to glass.
3 . Replace threaded plastic buttons.
A new type living area side window is now in
production on 1975 GMC MotorHomes and Trans-
Modes. The window assembly is identified by its one
piece sash and center latch and handle . The fiber
glass screen, the vent (sliding) glass, and the station-
ary glass are serviced with the window assembly in
the vehicle as follows:
SCREEN AND VENT ASSEMBLY
Removal
1 . Remove top screen track using reasonably stiff
wire shaped to form tool shown in Figure 9. Insert
tool at outer end of screen track and pull track from
window frame assembly, Figure 10.
2. Unlock window, open vent, and slide back
screen . Lift screen up and forward into sash assem-
bly. Then pull out.
"HEHR" LIVING AREA SIDE
WINDOW ASSEMBLIES
APPX . 7"
Figure 9-Fabricated Track Removal Tool