GMC 1976 ZEO 6083 Maintenance Manual page 163

3113- 1 2 DRIVE AXLES
3. Remove inner C.V . joint. Refer to Inner C.V .
Joint-Disassembly .
Joint - Assembly.
ASSEMBLY
1 . Assemble inner C.V. joint. Refer to Inner C.V.
Joint Assembly .
TORQUE SPECIFICATIONS
SPECIAL TOOLS
J-5586
Snap Ring Pliers
J-9397-2
C.V . Joint Cover Installer
J-22716
C.V . Joint Boot Clamp Tool
J-24319
Pitman Arm, Idler Arm, Ball Joint Puller
2. Assemble outer C.V . joint. Refer to Outer C.V.
3 . Install drive assembly . (Refer to DRIVE
AXLE ASSEMBLY - RIGHT OR LEFT INSTAL-
LATION) .
Application
Ft. Lbs.
R.H . Output Shaft Support to Engine Bolts . . . .. . . ... . ... . . ... . .... . ... . . . . . . . .. . . ... . . ... . . ... . . .. . . . .. . . .. . . .. . . . . . 55
Drive Axle to Output Shaft Bolts . .... . ... . . ... .... . ... . ... . ... . . ... . .... . ... . . . .. . . ... . .... . ... . . . .. . . .. . . . .. . . ... . ... . . .. 75
Drive Axle Nut at Wheel Hub .. . .... . ... . . .. . . . .. . ... . ... . .... . ... . ... . . ... . . .. . . . ... . .... . ... . . . . . . . .. . . ... . . ... . ... . ... . . 200
Tie Rod End to Knuckle Nut .. . . ... . . .. . . . .. . . .. . ... . . .. . . ... . ... . . .. . . . .. . . ... . . ... . . ... . . .. . . . .. . . . .. . .... . .. . . .... .... . .. 40
Ball Joint Stud Nuts . . ... . ... . .... . ... . . . .. . . .. . . . .. . . ... . .. . . . . . . . .. . . .. . . . .. . . ... . .... . . .. . . . .. . . .. . . . ... . .... . ... . . .. . . ... . ... . .. 60
Nut must be tightened to insert cotter pin .