IBM TS3100 Setup, Operator, And Service Manual page 87

Logging on to the Web User Interface
To complete the configuration of your library using the Web User Interface, follow
the steps below.
1. On your host computer, open an Internet browser.
2. In the browser address field, enter your library's IP Address.
3. When the login screen appears,
Figure 4-22. Log in screen on the Web User Interface
Verifying/Updating Firmware
It is important to run the latest level of firmware. To ensure that you are running
the latest levels of library firmware, drive firmware, and SNMP MIB (Management
Information Base) file, complete this procedure.
1. Verify the SNMP MIB file currently installed on your SNMP server. Verify the
you select CANCEL in the pop-up menu, you will need to power cycle the
library for the network changes to be applied.
v If CANCEL is highlighted, press the SELECT button to cancel all of your
entries and return to the Configure menu.
a. For DHCP and/or Stateless Autoconfig, use the Operator Control Panel to
determine the IP Address assigned to your library. Navigate to Monitor >
Library > Network. Scroll down to the library address information and
make note of the address. Enter the IP Address in your internet browser
address field to access your library with the Web User Interface. The library
address information may include one or more of the following address
types:
v IP Address (IPv4 static or DHCP)
v Static IPv6 Address
v Link Local IPv6 Address
v Assigned IPv6 address (DHCP or Stateless Autoconfig)
b. For IPv4, enter your library's IP Address using the 0.0.0.0 format (four
octets).
c. For IPv6, enter your library's IP Address using the following format:
http://[0:0:0:0:0:0:0:0].
d. For Dual Stack IPv4 + IPv6, enter your library's IP Address for either IPv4
or IPv6.
a. Select admin for a User ID.
b. Enter secure for a Password.
levels of library and drive firmware currently installed on your library by
completing the following steps:
a. Expand Monitor Library in the left navigation pane of the Web User
Interface.
Chapter 4. Installation and Configuration
4-21