Control: Move Cartridges Menu - IBM TS3100 Setup, Operator, And Service Manual

Attention: After closing the I/O Station, you must wait for the library to complete
its inventory before proceeding with normal library operations.
Control: Move Cartridges
Use this menu item to move cartridges in the library.
Source
Type
Figure 5-10. Control: Move Cartridges menu
To move a cartridge from point A to point B, you must make the following choices:
v Source Type - Drive, I/O station, magazine. Only the source type(s) that contain
v Source - the choices start with the choice made in the preceding item and then
v Volume Serial - the serial number of the cartridge
v Dest Type - the destination Drive, I/O station, magazine
v Dest - the choices start with the choice made in the preceding item and then
Control: Magazine
Use this menu item to unlock the cartridge magazines.
Control
Move Cartridges
Source
cartridges will be listed.
advances through all available choices.
Note: If the Attention LED is ON due to a suspect cartridge, that cartridge will
be identified by an exclamation point (!) when scrolling through the
source cartridges.
advances through all available choices.
Destination
Volume
Type
Serial
Destination
5-17
Chapter 5. Operations