Configure: Set Access Pin Menu - IBM TS3100 Setup, Operator, And Service Manual

v Netmask - the Network Mask address of the library
v IP Stack - the IP Stack manages static IP addresses
v Stateless autoconfig - allows IPv6 hosts to be configured automatically when
v Prefix length - the length of the IP address prefix
v Static IPv6 address - a static IPv6 address that has been assigned to the library
v Gateway - the Gateway address of the library
v Ethernet - the current speed setting of the ethernet interface
v DNS Server 1 - the first DNS server address
v DNS Server 2 - the second DNS server address
Note: If a host and domain name are entered instead of an address, the IPv4 or
Configure: Set Access PIN
Use this menu item to enable/disable, set or change the Access PIN (personal
identification number) which is used to restrict access to the Control, Configure,
and Service menus.
Note: Record the Access PIN and store this in a secure location for future
Figure 5-17. Configure: Set Access PIN menu
Setting the Operator Control Panel Access PIN using the Operator Control
Panel:
1. Navigate to Configure > Set Access PIN.
2. Press the SELECT button to highlight the first digit of the 4-digit Access PIN.
3. Use the UP and DOWN buttons to select each digit.
4. Press the SELECT button to move to the next digit.
5. Repeat these steps for repeating the Access PIN.
6. After entering the final digit, press the DOWN button and select one of the
connected to a routed IPv6 network
IPv6 address will be resolved from the DNS using that name. That address
will be stored in the library rather than the name. Therefore, if the address
changes, the name or a new address will have to be entered.
reference. Library configuration files, saved with the Save Library Config
menu, do not include the Access PIN.
following:
v Save - to apply your settings.
v Cancel - to delete your settings.
5-25
Chapter 5. Operations