IBM TS3100 Setup, Operator, And Service Manual page 239

Table 8-3. Warning Events (continued)
81 Fan Alert.
82 Clean request from drive.
83 Media Attention.
84 Drive reported warning or critical tape
alert flag.
85 Network problem.
86 Not enough cleaning cartridges present
to autoclean.
87 Drive disabled because it is not
supported for use in this library.
88 Drive firmware unchanged after
upgrade.
89 Power Supply Fan operation warning.
8A Power Supply has failed.
8B Power supply has failed.
8C Invalid Robotic Code.
8E Cleaning tape nearly expired.
8F I2C bus recovery.
92 VPD data have been restored from
EEPROM.
DB External cooling fan error (fan motion
has stopped).
The subcode indicates which drive sled
fan is affected
Subcode 01: drive sled #1(bottom)
Subcode 02: drive sled #2
2
DC I C Bus Failure
DD Power Supply x fan has failed,
Redundancy may be at risk
The subcode indicates which power
supply fan is affected
Subcode 01: 1st PS fan from bottom
Subcode 02: 2nd PS fan from bottom
DF Power Good signal changed from 2 to 1
Power Supplies
F6 No drive installed. A drive has never
been installed.
Check network connections, configuration, and settings.
Insert additional cleaning cartridges to the empty reserved
slots.
Check drive type and install only supported drives.
This is normal if the old and new drive firmware are the
same version.
Check the power supply status.
Check the power supply status and replace the failed power
supply.
Check the power supply status and replace the failed power
supply.
Install the latest version of library firmware.
Continue using cleaning cartridge until it is expired, then
replace the expired cleaning cartridge with a new cleaning
cartridge.
Run library System Test.
This is normal when the VPD has been restored EEPROM.
Refer to "Isolating Drive Sled Problems" on page 7-10.
Refer to "Isolating a Power Supply Problem" on page 7-8.
Install at least one drive.
8-13
Chapter 8. Error Codes