Kit A (Top Picture With Circles) Showing - IBM TS3100 Setup, Operator, And Service Manual

Figure 4-9. Kit A (top picture with circles) showing rails installed. Rack Kit B is below showing the front view of this kit
installed.
4. Using the Torx wrench included in your shipment, remove the screws ( 1 ) as
4-10
TS3100 Tape Library and TS3200 Tape Library Setup, Operator, and Service Guide
Note: The rail must be fastened with the bottom of the rail parallel to floor and
at the same level.
shown in Figure 4-10 on page 4-11. Screw locations on the 4U library are
similar.