IBM TS3100 Setup, Operator, And Service Manual page 122

v Identity
v Error Log
v Network
Under Monitor > Library > Status are the following items:
v Status - current status of the library
v Act. Cart - the serial number of the cartridge currently active in the library
v On Time - the amount of time the library has been powered ON
v Slots Empty - the number of empty slots in the library/total number of active
v Cycles - the total number of cartridge moves carried out by the library accessor
v I/O Station - indicates whether the I/O Station is open or closed
v Date/Time - gives the current date and time set in the library
Under Monitor > Library > Identity are the following items:
v Serial Number - the serial number of the library
v Version - the current level of library firmware installed
v Vendor ID - IBM
v Product ID - library inquiry string
v Active Slots - number of active slots in each logical library
v WWNN - World Wide Node Name of the library
v Library Mode - current library mode (Random or Sequential)
Under Monitor > Library > Error Log, you will have a list of errors logged by the
library. The errors will be displayed beginning with the most recent error.
Under Monitor > Library > Network are the following items:
v IP Stack - the internet protocol currently being used by the library
v DHCP - (Dynamic Host Configuration Protocol) - records whether DHCP is ON
v IP Addresses - the internet addresses of the library
v Stateless auto configuration - indicates whether or not stateless auto
v Prefix Length - the length of the IP Address prefix
v Netmask - the Network Mask Address of the library
v Static IPv6 Address - the static IPv6 address of the library
v Link Local IPv6 Address - local link-only IPv6 address of the library
v Assigned IPv6 Address - IPv6 address(es) discovered by the network router. This
v Gateway - the Gateway Address of the library
v Ethernet - the speed of the ethernet interface
Monitor: Drive
This menu item displays drive information and settings.
5-12
TS3100 Tape Library and TS3200 Tape Library Setup, Operator, and Service Guide
slots in the library
or OFF
configuration is enabled
will display only when DHCP is OFF and Stateless auto configuration is ON.