Attaching Host Interface Cables To The 4U; Attaching A Sas Interface Cable To The 2U - IBM TS3100 Setup, Operator, And Service Manual

Figure 4-17. Attaching a SCSI host interface cable to the 2U library
6
Figure 4-18. Attaching host interface cables to the 4U library.
Figure 4-19. Attaching a SAS interface cable to the 2U library
3. Attach the other end of the host interface cable as follows:
drives will have dual SAS connectors. Half high drives will have one SAS
connector. Unused SAS connectors do not need to be terminated.
1
4
1
1 2
v For a SCSI library, connect the host interface cable to the connector on the
SCSI host bus adapter or to the connector on the previous device on the SCSI
bus. Attach the terminator (
3
4
3 2
3
in Figure 4-17) to the remaining SCSI
Chapter 4. Installation and Configuration
2
5
3
4-15