Leader Pin In The Incorrect And Correct; Placing The Dislodged Leader Pin Into The Correct Position - IBM TS3100 Setup, Operator, And Service Manual

Figure 6-8. Leader pin in the incorrect and correct positions. The cartridge door is open and the leader pin is visible
inside the cartridge.
To reposition the leader pin, perform the following steps.
1. Slide open the cartridge door ( 1 in Figure 6-9) and locate the leader pin 2
2. With plastic or blunt-end tweezers, grasp the leader pin and position it in the
3. Press the leader pin gently into the clips until it snaps into place and is firmly
4. Close the cartridge door.
Figure 6-9. Placing the dislodged leader pin into the correct position. The cartridge door is open to show the leader
pin.
(you may need to shake the cartridge gently to roll the pin toward the door).
pin-retaining spring clips 3 .
seated.
Chapter 6. Using Ultrium Media
6-13