IBM TS3100 Setup, Operator, And Service Manual page 230

Table 8-1. Main Error Codes (continued)
Error Code Description
C0 Network initialization failed
C1 Telnet Interface initialization failed
C2 Webserver initialization failed
C6 Ping command did not reach target
C7 Cannot Upgrade from USB
C8 Cannot Upgrade from FTP
C9 Cannot Upgrade Robotic from Flash
D0 ROM error. ROM checksum incorrect
D1 RAM error. Power on Self Test ( POST ) has failed,
D2 NVRAM (Non-Volatile Random Access Memory) error.
Read/Write operation to NVRAM has failed
D3 CTC (Channel to Channel ) Error. Timer unit has failed during
POST.
D4 UART (Universal Asynchronous Receiver Transmitter ) Error.
Frame overrun or Parity Error on serial Interface.
D5 Display Error
Communication to display failed
D6 Memory Error, Stack and heap overflow.
D7 Fatal system error*
D8 Data base error**
D9 No SCSI IC detected
DA While running the Library Verify Test, the bar code reader read
different bar code data for the same customer-supplied scratch
cartridge label.
DB Warning Event! See Table 8-3 on page 8-11
8-4
TS3100 Tape Library and TS3200 Tape Library Setup, Operator, and Service Guide
User Action
1. Refer to "Isolating Web User
Interface Problems" on page 7-12.
2. If the error recurs, refer to
"Contacting IBM Technical
Support" on page 9-4.
Not supported
1. Retry the Firmware upgrade.
2. If the error recurs, refer to
"Contacting IBM Technical
Support" on page 9-4.
Refer to "Isolating a Library
Controller Card vs. Accessor
Enclosure Problem" on page 7-11.
Possible Replacement CRUs:
v Primary: Library Controller Card
v Secondary: Library Enclosure
*D7 - Fatal System error can occur
due to an over-temperature
condition. Ensure the environment
meets the Environmental
Specifications (refer to
"Environmental Specifications" on
page 1-13).
**If you receive a D8 error while
restoring your library configuration
from the OCP or Web UI, verify that
your file extension is .dbb. If the
extension is correct, your file may
have been corrupted during the save.
Reconfigure, then save your library
configuration.
Note: Configuration files saved with
one version of library firmware may
not be compatible with other
versions of firmware. It is
recommended to save a
configuration file each time the
library firmware is upgraded.
Restore the library using a
configuration file that was saved
with the same version of firmware
currently installed in the library.
1. Check the barcode label on the
scratch cartridge and run the
Library Verify test again..
2. If the error recurs, refer to
"Contacting IBM Technical
Support" on page 9-4.