Half High Drive With The Connection Card Moved To The Side Showing The Screws; The Drive Brick Showing The Cables To Be - IBM TS3100 Setup, Operator, And Service Manual

Figure A-3. Half high drive with the connection card moved to the side showing the screws
Figure A-4. The drive brick showing the cables to be unplugged
b. Carefully pull the drive brick out of the front of the sled far enough to
unplug the signal cable (SCSI, Fibre Channel or SAS 5 ).
c. With the signal cable unplugged, carefully pull the drive brick out so that
the power cable ( 6 ) and the RS-422 cable ( 7 ) can be accessed and
unplugged.
Note: The SAS signal cable also contains the power cable.
Appendix A. Information for Trained Service Personnel
A-5