Removing And Storing The Shipping Lock; Installing Foot Pads On The Bottom Of The - IBM TS3100 Setup, Operator, And Service Manual

3. Install the foot pads on the bottom of the library enclosure by pressing each
Figure 4-1. Installing foot pads on the bottom of the library enclosure
4. Carefully return the library to an upright position.
Important: Do not place any objects on top of the library.

Removing and Storing the Shipping Lock

Important: The shipping lock, which prevents the library accessor from moving
The shipping lock is held in place with a label and is located in the top center of
the library. After the shipping lock is removed, it should be stored on the right side
of the back panel of the library for future use.
To remove and store the shipping lock:
4-4
TS3100 Tape Library and TS3200 Tape Library Setup, Operator, and Service Guide
foot into one of the six areas ( 1 ) as shown in the figure below.
during shipment, must be removed before the library is powered ON.
1