Replacing A Power Supply; Popping The Slot Blocker Out Of The Cell - IBM TS3100 Setup, Operator, And Service Manual

Figure 10-11. Popping the Slot Blocker out of the Cell
3. Slide the magazine back into the rack.
4. After the accessor runs through the inspection, a REMOVE SLOT
5. Choose the YES option. You can replace the empty cell with a data cartridge.

Replacing a Power Supply

RESTRICTION? message will appear on the main menu screen.
1. Power OFF the library by pressing and holding down the power button for 4
seconds.
2. Disconnect the power cord from the electrical source, then from the library.
3. Loosen the three blue captive thumbscrews on the power supply located on
the back panel of the library.
4. Pull on two of the thumbscrews to pull the unit away from the rear panel of
the library, then grasp the top and bottom edge of the power supply and pull
it out of the library.
Chapter 10. Check, Adjust, Remove, and Replace
10-11