Gearshift Linkage - Honda CBF600SA Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
CLUTCH/STARTER CLUTCH/GEARSHIFT LINKAGE
Apply engine oil to the starter clutch mounting bolt
threads and seating surface.
Install the washer and starter clutch mounting bolt.
Temporarily install the following:
– clutch outer
– clutch outer guide
– clutch outer needle bearing
Attach the gear holder between the primary drive
Be careful not to
gear and driven gear.
drop the gear
holder into the
TOOL:
crankcase.
Gear holder, M2.5
Tighten the starter clutch mounting bolt to the spec-
ified torque.
TORQUE: 83 N·m (8.5 kgf·m, 61 lbf·ft)
Remove the temporarily installed parts.
Apply molybdenum oil solution to the starter reduc-
tion gear sliding surface.
Install the starter reduction gear into the crankcase.
Install the clutch (page 9-13).

GEARSHIFT LINKAGE

REMOVAL
Remove the following:
– right crankcase cover (page 9-5)
– clutch (page 9-6)
Remove the pinch bolt and disconnect the gearshift
arm from the gearshift spindle.
9-22
email: info@motomatrix.co.uk
07724-0010100
GEARSHIFT ARM
CLUTCH OUTER
GEAR HOLDER BOLT/WASHER
STARTER REDUCTION GEAR
PINCH BOLT
BOLT/WASHER