Wheel Speed Sensor - Honda CBF600SA Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.
ANTI–LOCK BRAKE SYSTEM (ABS; CBF600SA/NA)
7. Logic Ground Line Open Circuit Inspection
Remove a jumper wire from the ABS modulator
25P connector.
Short the Red/black and Green/orange #1 wire
terminals of the 25P connector with a jumper
wire.
Check the ABS indicator with the ignition switch
turned to "ON".
Does it go off?
YES
NO

WHEEL SPEED SENSOR

AIR GAP INSPECTION
Support the motorcycle securely using a hoist or
equivalent and raise the wheel off the ground.
Measure the clearance (air gap) between the sensor
and pulser ring at several points by turning the
wheel slowly.
It must be within specification.
STANDARD: 0.2 – 1.2 mm (0.01 - 0.05 in)
The sensor air gap cannot be adjusted.
If it is not within specification, check each installa-
tion part for deformation, looseness and damage.
REPLACEMENT
FRONT WHEEL SPEED SENSOR
Lift and support the fuel tank (page 3-5).
Disconnect the front wheel speed sensor 2P (Blue)
connector.
16-24
email: info@motomatrix.co.uk
– • Faulty ABS modulator.
– • Open circuit in Green/orange wire
between the ABS modulator and
body ground.
MODULATOR 25P CONNECTOR
(Wire side/female terminals)
Red/black
Green/orange #1
Front:
Rear:
2P (Blue) CONNECTOR