Oil Pressure Inspection - Honda CBF600SA Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys.

OIL PRESSURE INSPECTION

Remove the rubber cap from the EOP switch.
If the oil pressure
indicator light
Remove the terminal bolt and disconnect the EOP
remains on while
switch wire.
the engine is
Remove the EOP switch while holding the switch
running, check the
base.
indicator system
before checking the
oil pressure.
Install the oil pressure gauge attachment to the
switch base.
Connect the oil pressure gauge to the oil pressure
gauge attachment.
TOOLS:
Oil pressure gauge set
Oil pressure gauge attach-
ment
Check the oil level and add the recommended oil if
necessary (page 3-15).
Warm the engine to normal operating temperature
(approximately 80°C/176°F) and increase the engine
speed to 6,000 min
OIL PRESSURE:
496 kPa (5.1 kgf/cm
(80°C/176°F)
Stop the engine and remove the tools.
Apply a sealant to the EOP switch threads as shown.
email: info@motomatrix.co.uk
07506-3000001 or
equivalent
commercially avail-
able
07510-4220100 or
equivalent
commercially avail-
able
-1
(rpm) and read the oil pressure.
2 -1
, 72 psi) at 6,000 min (rpm)/
LUBRICATION SYSTEM
RUBBER CAP
OIL PRESSURE GAUGE
Do not apply to the thread head
3 - 4 mm (0.1 - 0.2 in)
TERMINAL BOLT
EOP SWITCH
ATTACHMENT
EOP SWITCH
4-5