Using The Memory; Registering To Memory Channels; Recalling A Memory Channel - Yaesu FT3DR Operating Manual

Using the Memory

The information registered to memory channels can be corrupted by incorrect operation, static
electricity, or electrical noise. Also, it can be erased in the event of a failure or repair. Be sure
to keep a record of the settings on paper or back up the data to the microSD memory card. For
details on saving a backup onto a microSD memory card, see "Set Mode: SD CARD Menu Opera-
tions" on page xxx.

Registering to Memory Channels

1. Set the frequency and the communication mode to be
registered to a memory channel.
2. Touch and hold [F MW].
3. Rotate the DIAL knob to select the desired channel
number.
4. Touch [M.WRITE].
• If you attempt to register a frequency to a memo-
ry channel that already contains frequency data,
"OVERWRITE?" will appear on the LCD. Touch [OK]
twice to overwrite the memory channel.
• The beep sounds and the memory is saved.

Recalling a Memory Channel

1. Press the [V/M] key.
The memory channel most recently used appears on the display.
2. Rotate the DIAL knob to select the desired memory channel.
3. Press the [V/M] key to exit the memory mode, and return to the normal operation.
The data registered to a memory channel can be transferred to the VFO operating band
by following the procedure below:
Touch and hold ［F MW］
appears
The transceiver may be placed into a Memory Channel Only mode, (which restricts
the FT3DR to operate only on the memory channels), by pressing the [V/M] key, while
pressing the Power (Lock) switch to turn the transceiver ON. To cancel the Memory
Channel Only mode, turn the transceiver OFF, then press the [V/M] key again, while
pressing Power (Lock) switch to turn the transceiver ON.
24
Touch [
Touch ［OK］ twice.
Caution
] Touch [V.WRITE］ "OVERWRITE?"