Fireback Installation - Travis Industries 1080 CF Installation Manual

56 Finalizing the Installation

Fireback Installation

WARNING Turn off gas to the appliance and make sure it has fully cooled prior to conducting service.
WARNING The firebacks are fragile (especially after being burned) – handle with care.
NOTE The firebacks are 2-sided. When installing, use the desired pattern. Also make
sure the rear brick is correctly positioned.
1 Remove the glass frame, logs, and grate.
2 Remove and discard the ember tray and burner tray cover..
Remove this clip on
the firebox floor.
c
Remove and discard
the ember tray and
the burner tray cover.
Remove this clip on the firebox
floor. Bend the clip upwards to
© Travis Industries
(Rectangular 96100172)
Herringbone Pattern
Loosen the screw and remove the clips located on
the firebox ceiling (both sides).
a
b
form a 90° angle.
4090807
(for qualified installers only)
Brick Pattern
UP
d
UP
100-01193_003
Figure 38