Table of Contents
Advertisement
52
Finalizing the Installation
Fireback Installation
STAINLESS STEEL WARNINGS
HANDLING THE FIREBACKS: The stainless steel firebacks are shipped in vinyl to prevent marring the surface
of the stainless steel. Remove the vinyl prior to installation. Wear clean gloves when installing the firebacks
to prevent fingerprints on the surface (or use a rag or paper towel to handle the firebacks).
COLORATION AND CLEANING: These stainless steel firebacks will obtain a slight "patina" (brown tint) after
use. Do not clean the firebacks. This patina becomes consistent. Any cleaning may lead to unequal coloring.
If soot forms on the fireback, we recommend brushing it off with a soft cloth or brush.
CLEANING ENAMEL FIREBACKS
We recommend cleaning the enamel surface with glass cleaner and a soft cloth.
WARNING
Metal firebacks are required for the 564 Diamond-Fyre. Install the firebacks prior to test-
burning the fireplace. Install the firebacks prior to installing the crushed glass. Make
sure the appliance is cool and electricity has been shut off to the fireplace before
installation.
1
Remove the glass frame (see manual for details).
2
Remove the cast burner cover and place it aside.
3
Remove the four screws securing the glass tray. Lift the tray up and place it aside.
NOTE: If you are converting the fireplace to LP (Propane), convert it at this time with the glass tray
removed.
© Travis Industries
(for qualified installers only)
4140926
100-01395
Advertisement
Table of Contents
