Travis Industries 1080 CF Installation Manual page 54

54 Finalizing the Installation
6 Switch the pilot hood to the "LP" size following the directions below.
Un-screw the pilot
hood 1/4 turn.
NOTE: The sliding portion of the pilot orifice may be positioned differently. Instead of pulling it
towards you, you may push it away. Either way – when the hole appears near the tab, the orifice is
in the LP position.
7 Disconnect the burner tray and place it on the firebox floor (see Figure 35).
The gas control valve and receiver
module are found on the back side of
this plate.
© Travis Industries
Slide this silver tab out.
4090807
(for qualified installers only)
When in the LP position a hole
will appear near one of the tabs.
Tighten the pilot hood
until it is fully secure.
Figure 34
The burner tray is held
in place with 9 screws
(7 on the firebox wall, 2
on the pilot assembly).
Remove the burner tray
and place it on the
firebox floor.
Figure 35
100-01193_003