Travis Industries 1080 CF Installation Manual page 52

52 Finalizing the Installation
3 Remove the firebox floor following the directions below.
a
Remove the four
screws that secure
the firebox floor.
4 Remove the burner following the directions below.
Remove the four
screws securing
the burner to the
firebox floor.
Slide the burner to
the right and up to
remove.
© Travis Industries
(for qualified installers only)
Tilt the front of the firebox floor upwards
b
slide it forward, and remove.
NOTE: These tabs insert into the
slots on the back of the firebox floor.
4090807
NOTE: The air
shutter inserts
through this slot.
When re-attaching
the floor, position
the air shutter so it
inserts through the
slot.
Figure 31
Figure 32
100-01193_003