Fireback Installation - Travis Industries 36 CF II Installation Manual

38 Finalizing the Installation

Fireback Installation

WARNING Turn off gas to the appliance and make sure it has fully cooled prior to conducting service.
WARNING The firebacks are required on this fireplace and must be installed prior to operation.
WARNING The firebacks are fragile (especially after being burned) – handle with care.
NOTE The firebacks are 2-sided. When
installing, use the desired pattern.
Also make sure the rear brick is
correctly positioned.
1 Remove the glass frame, logs, and grate.
2 Install the firebacks following the directions
below.
Replace the clip to secure the
side fireback (both sides).
e
While holding the rear firebacks in
place, slide the side firebacks
between the burner and side wall of
the firebox. The side firebacks hold
the back firebacks in place.
3 Restore the fireplace to the correct configuration.
© Travis Industries
(Arched 96100166, Rectangular 96100172)
Remove the clip and screw located on the firebox
ceiling near the front (both sides).
b
Place the floor firebacks in the gap in
front of the burner. Bend the 3 tabs
on the burner down to secure the
floor firebacks.
d
(for qualified installers only)
Herringbone Pattern
a
Left Floor
Fireback
Place the rear firebacks in
place. Note how the lower
fireback rests on the ledge
at the back of the firebox.
4100519
Brick Pattern
UP
c
100-01197_001
UP
Figure 26