Battery Installation - Travis Industries 1080 CF Installation Manual

22
INSTALLATION WARNING – Remote Synchronization
At this time we highly recommend you verify the remote and wireless wall switch are synchronized.
This process requires access to the receiver module – a component that is easily accessed when
the side of the fireplace is exposed. See the instructions on page 23 for details.

Battery Installation

This fireplace requires batteries for the remote, wireless wall switch, and battery box. We
recommend the batteies be replaced every year to insure proper operation. Follow the directions
below to install.
The Wall Switch requires two (2) CR2032 3V
batteries (included).
NOTE: The positive side (+) faces outwards.
CR2032
© Travis Industries
Installation
Battery Pack
(make sure this switch is
set to "DC Motor Drive")
Wireless Wall Switch
CR2032
(for qualified installers only)
The battery pack requires four
(4) AA batteries (not included)
The Remote requires two (2) AAA batteries (included)
Cover Plate
(snaps into place)
Back of Remote
4090807
Figure 15
100-01193_003