20
Steps for Installing the Battery Pack and Wall Switch
1. Connect the battery pack wire harness to the receiver module where it is marked "AUX" (see
Figure 12 – item "a").
remote switch is set to "REMOTE" on the receiver module (see Figure 12 – item "b"). You may
also wish to verify the wires leading from the receiver are fully attached.
2. Connect the DCMD wires (red and red/black) to the two wires (red and black) exiting the motor
assembly on the gas control valve (see Figure 12 – item "c").
Battery Box
DCMD Wires (DC Motor Drive) - 12' Length
Red and Black/Red wires (w quick connects)
c
Pilot Flame Control Wires
© Travis Industries
Installation
At this time make sure the continuous pilot switch is set to "OFF" and the
Battery Box Wires (DC Motor Drive) - 12' Length
Black, Brown, Red, and Orange wires
AC Adapter
(wire orientation does not matter)
Gas Control Valve
Main Burner Control Wires
(for qualified installers only)
a
Receiver
Module
Not
Used
White
Green
Orange
White
4090807
Pilot Assembly
Igniter ("I") Wire
(Orange - with
fiberglass
insulation)
Sensor ("S")
Wire (White)
b
Make sure continuous pilot
is set to "OFF" and remote
is set to "REMOTE".
Figure 12
100-01193_003