Synchronizing The Remote And Wireless Wall Switch - Travis Industries 1080 CF Installation Manual

24

Synchronizing the Remote and Wireless Wall Switch

NOTE: The battery box, remote, and wall switch must have batteries to complete this process.
WARNING: Shut the gas off to the fireplace prior to conducting this process.
Use the reset rod (see instructions on
the following page) to press the reset
("Learn") button on the receiver module
until it beeps once.
Use the reset rod (see instructions on
the following page) to press the reset
("Learn") button on the receiver module
until it beeps once.
NOTE: Re-setting the Receiver Module
If the receiver module fails to synchronize with the remote or wall switch after two attempts, you
should re-set the receiver module. To do this, hold down the LEARN button on the reciever for
approximately 10 seconds until the receiver beeps 3 times. This indicates the receiver has been
re-set and can be synchronized using the instructions above.
The receiver module has enough memory to store three remotes. If you re-synchronize the
remotes, you may overwhelm the receiver memory, nullifying one of the earlier programmed
remotes. In these cases, you should reset the receiver module and re-synchronize.
© Travis Industries
Installation
(for qualified installers only)
Press the "OFF" button on the remote.
Beep
Press the "OFF" button on the wireless
wall switch.
Beep
4090807
The receiver will acknowledge the
signal by beeping 5 times.
Beep, Beep,
Beep, Beep,
Beep
The receiver will acknowledge the
signal by beeping 5 times.
Beep, Beep,
Beep, Beep,
Beep
100-01193_003