Subaru Select Monitor - Subaru LEGACY 2004 Service Manual

LAN SYSTEM (DIAGNOSTICS)

6. Subaru Select Monitor

A: OPERATION
1. READ DIAGNOSTIC TROUBLE CODE
(DTC)
NOTE:
• DTC is displayed in the sequence of inputting.
(When inputting more than two simultaneously,
DTC is displayed in the sequence of priority.)
• When more than two DTCs are displayed, per-
form the diagnosis of top of them.
1) Prepare the Subaru Select Monitor kit.
2) Connect the diagnosis cable to Subaru Select
Monitor.
3) Insert the cartridge to Subaru Select Monitor.
<Ref. to LAN(diag)-6, SPECIAL TOOL, PREPARA-
TION TOOL, General Description.>
4) Connect the Subaru Select Monitor to data link
connector.
Data link connector is located in the lower portion of
the instrument panel (on the driver's side).
Subaru Select Monitor
CAUTION:
Do not connect scan tools except for Subaru
Select Monitor.
5) Turn the ignition switch to ON (engine OFF) and
turn the Subaru Select Monitor switch to ON.
6) On the «Main Menu» display screen, select the
{Each System Check} and press the [YES] key.
7) On the «System Selection Menu» display
screen, select the {Integ. Unit mode} and press the
[YES] key.
LAN00014
8) On the «Integ. Unit mode failuer diag» display
screen, select the {Diagnostic Code(s) Display}
and press the [YES] key.
NOTE:
• For details concerning operation procedure, re-
fer to "SUBARU SELECT MONITOR OPERATION
MANUAL".
• For details concerning DTCs, refer to the List of
Diagnostic Trouble Code (DTC). <Ref. to LAN(di-
ag)-28, List of Diagnostic Trouble Code (DTC).>
ST
LAN00015
LAN00110
LAN(diag)-14
(A) Power switch
(A)
LAN00017