• Wagon model
A
A
(1)
(a)
Apply the apply tape with aligning
the cut out to the end of rear gate
panel.
(1)
Letter mark
(2)
Apply tape
2. AWD STICKER
Apply the AWD sticker from inside of glass with following dimension.
• Sedan model
(1)
(a)
Apply the apply tape with aligning
the cut out to the end of rear glass
center.
(1)
1 mm (0.04 in)
(2)
Gradation end of ceramic print
(with rear wiper)
Ornament
(a)
B
(a)
A-A
(b)
Apply the apply tape with aligning
outer bottom end of rear gate gar-
nish.
(3)
Rear gate garnish
(a)
(3)
Gradation end of ceramic print
(without rear wiper)
EI-79
(3)
(b)
(2)
(2)
(c)
Align the slit of apply tape to panel
end.
(4)
Rear combination light
(2)
(4)
(4)
End of rear glass
EXTERIOR/INTERIOR TRIM
(4)
(C)
B-B
EI-00816
(3)
EI-00741