Roof Molding - Subaru LEGACY 2004 Service Manual

EXTERIOR/INTERIOR TRIM

16.Roof Molding

A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the roof carrier attachment cover, and
remove the bolts. (2 places for each side)
3) Pull the roof molding upward, and remove it from
vehicle body.
(1)
(3)
(1) Locating pin
(2) Roof molding
(3) Cap
(4) Clip
(5) Grommet
4) Remove the roof trim. <Ref. to EI-67, REMOV-
AL, Roof Trim.>
Roof Molding
EI-00658
(2)
(5)
(4)
EI-00660
5) Remove the nuts, and remove the roof carrier at-
tachment.
B: INSTALLATION
Install in the reverse order of removal.
CAUTION:
Replace the clip with new one when the broken
pin grommet is found during the removal of
roof molding. When the body side cap or clip is
damaged, or the roof molding is lifted or peeled
from body, be sure to repair them correctly, be-
cause those troubles may cause the water leak-
age.
Tightening torque:
!
7.5 N m (0.76 kgf-m, 5.5 ft-lb)
EI-46
EI-00659