Subaru LEGACY 2004 Service Manual page 735

6) Change the setting with UP/DOWN key and press the [YES] key.
• List of body integrated unit registration item
NOTE:
Setting is different depending on grade of vehicle.
Data
21 A/C ECM setting
22 P/W ECM setting
23 Center display failure (OP)
24 Wiperdeicer (OP)
25 Rear fog light setting (OP)
Factory initial setting
26 (Reset of body integrated
unit)
CAUTION:
• It is possible to control the original functions of vehicle when registrations of body integrated unit
and function setting are corresponded to vehicle equipment.
• When body integrated unit is new one or "Factory" mode, key illumination blinks to show equip-
ment settings does not completed.
• Be sure not to change Factory initial setting except installation of new body integrated unit.
NOTE:
• "Factory" mode:
• Body integrated unit has been not set yet. It can be recognized by key illumination blinking with ignition
switch turned to ON.
• All body integrated units as part for repair are set to "Factory" mode. When replacing a body integrated
unit, be sure to perform the registration operation.
• "Market" mode:
Each settings have been set. It can be recognized by key illumination coming on in concocting with room
light and going off with ignition switch turned to ON.
Subaru Select Monitor
Initial setting Registration
ON
OFF
OFF
ON
OFF
OFF
ON
OFF
OFF
ON
OFF
OFF
ON
OFF
OFF
Factory (Reset)
Factory
Market (Settlement)
LAN(diag)-19
LAN SYSTEM (DIAGNOSTICS)
Remarks
Illumination control does not operate if A/C ECM
setting is set to "OFF" in case of model with auto
A/C.
If A/C ECM setting is set to "ON" in case of model
without auto A/C, illumination change to night illu-
mination and it is difficult to be recognized.
Be sure to set P/W ECM setting to "OFF".
Auto-reverse function
Information may not be displayed on center display
if Center display failure is set to "OFF" in case of
model with center display.
ON signal does not output with operation of wiper
deicer switch if Wiperdeicer is set to "OFF" in
model with wiper deicer.
Vehicle is controlled in rear fog light equipped
mode.
Vehicle is controlled in rear fog light no-equipped
mode. (Be sure to set to "OFF" in model without
rear fog light.
If Factory initial setting is set to "Factory", registra-
tions of items above is changed to "OFF". Be sure
to set to "Market".