Subaru LEGACY 2004 Service Manual page 733

Items to be displayed
Auto A/C failure
EBD Warning Light
ABS Warning Light
VDC OFF flag
VDC/ABS OK B
VDC/ABS condition
Destinat.
Touch SW
5. CONFIRMATION OF CURRENT SETTING
1) On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display screen, select the {Integ. Unit mode} and press the [YES] key.
3) On the «Integ. Unit mode failuer diag» display screen, select the {Current Data Display & Save} and press
the [YES] key.
4) On the «Current Data Display & Save» display screen, select the {12 Data Display} and press the [YES]
key.
5) Using the scroll key, scroll the display screen up or down until the desired data is shown.
6) Display the following items and record the settings.
Required items for new registration (Except for system not equipped)
Item
Key No. to register
Off delay
Auto-lock
Rr defogger op. mode
Wiper deicer op. mode
Security Alarm Setup
Impact Sensor Setup
Alarm monitor delay setting
Lockout prevention
Impact Sensor
Siren setting
Answer-back buzzer setup
Hazard answer-back setup
Automatic locking setup
Ans.-back Buzzer
Auto locking
Door open warning (prevention of battery
run-out)
A/C ECM setting
P/W ECM setting
Center display failure
Wiper deicer
Rear fog light setting
Factory initial setting
Security setting (Specified security set-
ting)
Subaru Select Monitor
Unit of measure
OK/NG
OK/OFF
OK/OFF
ON/OFF
OK/NG
0 — 4
0 — 16
0 — 64
Item to confirm
1 2
OFF Long
60, 50, 40, 30, 20
Normal
Normal
ON
ON
ON
ON
Yes
Yes
ON
ON
ON
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Manufacture
Yes
LAN(diag)-17
LAN SYSTEM (DIAGNOSTICS)
NOTE:
For details concerning operation procedure, refer
to "SUBARU SELECT MONITOR OPERATION
MANUAL".
3 4
Normal Short
OFF
Continuous
Continuous
OFF
OFF
OFF
OFF
No
No
OFF
OFF
OFF
No
No
No
No
No
No
No
No
Market Not change to Manufacture mode
Operate the selected security set.
No
Remarks
Registered ID type
Setting for lighting off time
(Unit sec.)
Optional setting
Optional setting
Optional setting
Optional setting
Not equipped
Not equipped
Model with auto A/C
Not equipped
Model with center display
Optional setting
Optional setting
(EK model)