Subaru LEGACY 2004 Service Manual page 587

Instrument Panel Assembly
EXTERIOR/INTERIOR TRIM
3. INSTRUMENT PANEL ASSEMBLY (IN-
CLUDING STEERING SUPPORT BEAM)
1) Insert the matching pins (3 places) on the instru-
ment panel tip into the grommet (A) and (B) on the
body panel side.
(B)
(A)
(B)
EI-00621
2) Check the inserted state of matching pins, and
pull the harness around.
3) Temporarily tighten the steering support beam
with bolt, and pull the harness around.
4) Make sure that there is no mutual interference in
each pedal, and tighten the each bolt.
Tightening torque:
!
25 N m (25.5 kgf-m, 18.4 ft-lb)
5) Install in the reverse order of removal.
EI-59