Front Bumper - Subaru LEGACY 2004 Service Manual

EXTERIOR/INTERIOR TRIM

8. Front Bumper

A: REMOVAL
1. FRONT BUMPER FACE
1) Disconnect the ground cable from battery.
2) Remove the front grille. <Ref. to EI-24, REMOV-
AL, Front Grille.>
3) Turn over the front mud guard, and remove the
clips connecting the fender and bumper.
4) Remove the clips at the lower side of bumper.
5) Disconnect the fog light connector. (Model with
fog light)
6) Remove the bumper from vehicle body.
7) Remove the fog light from bumper face. <Ref. to
LI-21, REMOVAL, Front Fog Light Assembly.>
Front Bumper
2. FRONT BUMPER BEAM ASSEMBLY
1) Disconnect the ground cable from battery.
2) Remove the front grille. <Ref. to EI-24, REMOV-
AL, Front Grille.>
3) Remove the front bumper face. <Ref. to EI-30,
FRONT BUMPER FACE, REMOVAL, Front
Bumper.>
4) Remove the energy absorber foam from bumper
beam.
5) Remove the bolts, and remove the bumper
beam assembly from vehicle body.
EI-00572
NOTE:
After all bolts are removed, raise the whole bumper
beam a little to remove it from vehicle body.
6) Remove the bolts and nuts, and disassemble the
bumper beam.
EI-00573
EI-30
EI-00575
EI-00576
EI-00577