Rear Shelf Trim - Subaru LEGACY 2004 Service Manual

EXTERIOR/INTERIOR TRIM

31.Rear Shelf Trim

A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the rear quarter trim. <Ref. to EI-63,
SEDAN MODEL (MODEL WITH CURTAIN AIR-
BAG), REMOVAL, Rear Quarter Trim.>
3) Remove the high-mounted stop light. <Ref. to LI-
33, REMOVAL, High-mounted Stop Light.>
4) Remove the rear seat cushion. <Ref. to SE-14,
WAGON MODEL, REMOVAL, Rear Seat.>
5) Remove the lower anchor bolt of rear center seat
belt.
6) After disconnecting the high-mounted stop light
harness connector (A) and removing the five clips,
remove the rear shelf trim with pulling it frontward.
Rear Shelf Trim
EI-00675
(A)
EI-00676
EI-70
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Securely insert the vehicle body panel into the hook
of rear shelf trim center, and then install the rear
shelf trim.
(1)
(1) Hook
(2) Rear shelf trim
(3) Vehicle body panel
(2)
(3)
EI-00739