Subaru LEGACY 2004 Service Manual page 731

2. READ CURRENT DATA
1) On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display screen, select the {Integ. Unit mode} and press the [YES] key.
3) On the «Integ. Unit mode failuer diag» display screen, select the {Current Data Display & Save} and press
the [YES] key.
4) On the «Current Data Display & Save» display screen, select the {12 Data Display} and press the [YES]
key.
5) Using the scroll key, scroll the display screen up or down until the desired data is shown.
• A support list contains both of analog and digital data, and they are shown in the following table.
3. DISPLAY OF ANALOG DATA
Items to be displayed
BATT Voltage (Control)
BATT Voltage (BACK UP)
IG power supply voltage
ACC voltage
Illumination VR voltage
Illumi. output d-ratio
ambient temp sensor V
Ambient temperature
Fuel level voltage
Fuel level resistance
key-lock solenoid V
number of regist.
Front Wheel Speed
VDC/ABS latest f-code
Blower fan steps
Fuel level resistance2
Fuel consumption
Coolant Temp.
Vehicle lateral G
SPORT Shift Stages
Shift Position
Off delay time
Auto lock time
Subaru Select Monitor
Unit of measure
10 — 15 V
10 — 15 V
10 — 15 V
10 — 15 V
0 — 5 V
0 — 100%
0 — 5 V
!40 — 87.5$C
0 — 8 V
0 — 102.3 "
6 — 12 V
0 — 4
km/h
DTC display (Temporarily)
0 — 2 level
0 — 102.3 "
cc/s
!40 — 130$C
2
m/s
0 — 7 levels
0 — 7 levels
OFF, Short, Normal, Long
20, 30, 40, 50, 60 seconds
LAN(diag)-15
LAN SYSTEM (DIAGNOSTICS)
NOTE
—
—
—
—
—
—
—
—
—
Body integrated unit input value
—
—
—
This is normal when the DTC is not input
though the this code is displayed
0: OFF, 1: Low, 2: More than 2 level
Body integrated unit output
—
—
—
(0: light OFF, 6: fail, 7: ATF temperature
High/Low)
(8 is no input)
—
—