Neutral Position Switch - Subaru LEGACY 2004 Service Manual

Neutral Position Switch

CRUISE CONTROL SYSTEM
7. Neutral Position Switch
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Disconnect the connector from neutral position
switch, and then remove the switch. <Ref. to 5MT-
41, BACK-UP LIGHT SWITCH AND NEUTRAL
POSITION SWITCH, REMOVAL, Switches and
Harness.>
B: INSTALLATION
Install in the reverse order of removal.
C: INSPECTION
Measure the neutral position switch resistance.
2 1
MT-00110
Gear shift position Terminal No. Standard
Less than 1 !
Neutral position
1 and 2
Other positions More than 1 M!
If NG, replace the neutral position switch.
CC-9