Rear Gate Latch Assembly - Subaru LEGACY 2004 Service Manual

13.Rear Gate Latch Assembly

A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the rear gate trim. <Ref. to EI-69, RE-
MOVAL, Rear Gate Trim.>
3) Remove the two screws.
4) Remove the rear gate latch cover. (Model with
double lock)
(2)
(1)
(1) Clip
(2) Claw
(3) Hook
Rear Gate Latch Assembly
5) Disconnect the each connector and rear gate
handle cable.
SL-00240
(3)
6) Remove the rear gate latch assembly.
B: INSTALLATION
SL-00286
Install in the reverse order of removal.
NOTE:
Make sure the lock works correctly after installa-
tion.
C: INSPECTION
1) Disconnect the rear gate lock actuator harness
connector.
2) Connect the battery to rear gate lock actuator
terminals.
SL-37
(1)
(2)
(1) Rear gate handle cable
(2) Rear gate lock actuator connector
(3) Rear gate latch switch connector
2 1
Terminal No.
No. 2 (+) and No. 1 (")
No. 1 (+) and No. 2 (")
SECURITY AND LOCKS
(2)
(3)
SL-00301
SL-00235
Actuator operation
Unlocked $ Locked
Locked $ Unlocked