Subaru Select Monitor - Subaru Legacy 2003 Service Manual

ENGINE (DIAGNOSTICS)

10. Subaru Select Monitor

A: OPERATION
1. HOW TO USE SUBARU SELECT MONI-
TOR
1) Prepare Subaru Select Monitor kit. <Ref. to
EN(H4SO)-8, PREPARATION TOOL, General De-
scription.>
2) Connect diagnosis cable to Subaru Select Mon-
itor.
3) Insert cartridge into Subaru Select Monitor.
<Ref. to EN(H4SO)-8, PREPARATION TOOL,
General Description.>
4) Connect Subaru Select Monitor to data link con-
nector.
(1) Data link connector (A) located in the lower
portion of the instrument panel (on the driver's
side).
( A )
SUBARU SELECT MONITOR
EN-00038
ST
EN-00039
EN-00710
EN(H4SO)-32
(2) Connect diagnosis cable to data link con-
nector.
CAUTION:
Do not connect scan tools except for Subaru
Select Monitor and OBD-II general scan tool.
5) Turn ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
(A) Power switch
6) Using Subaru Select Monitor, call up diagnostic
trouble code(s) and various data, then record them.
2. READ DIAGNOSTIC TROUBLE CODE
(DTC) FOR ENGINE. (NORMAL MODE)
Refer to Read Diagnostic Trouble Code for infor-
mation about how to indicate DTC. <Ref. to
EN(H4SO)-39, Read Diagnostic Trouble Code.>
3. READ DIAGNOSTIC TROUBLE CODE
(DTC) FOR ENGINE. (OBD MODE)
Refer to Read Diagnostic Trouble Code for infor-
mation about how to indicate DTC. <Ref. to
EN(H4SO)-39, Read Diagnostic Trouble Code.>
( A )
EN-00040