Subaru LEGACY 2004 Service Manual page 736

LAN SYSTEM (DIAGNOSTICS)
7) Perform the Factory setting. On the «ECM cus-
tomizing» display screen of Subaru Select Monitor,
select the {Factory initial setting} and press the
[YES] key.
8) Change the mode from Factory into Market.
9) Replace the immobilizer cartridge, and register
the immobilizer key. (Model with immobilizer)
10) Perform the registration according to the proce-
dures of "IMMOBILIZER REGISTRATION MANU-
AL".
11) When key registration is completed, "Do you
want to register remote engine start?" is displayed.
Perform the registration only if equipped.
12) Perform the function setting (ECM customiz-
ing).
<Ref. to LAN(diag)-21, FUNCTION SETTING
(ECM CUSTOMIZING), OPERATION, Subaru Se-
lect Monitor.>
NOTE:
For details concerning operation procedure, refer
to "SUBARU SELECT MONITOR OPERATION
MANUAL".
7. CLEAR MEMORY MODE
1) On the «Main Menu» display screen, select the
{2. Each System Check} and press the [YES] key.
2) On the «System Selection Menu» display
screen, select the {Integ. Unit mode} and press the
[YES] key.
3) Press [YES] key after displayed the information
of body integrated unit type.
4) On the «Integ. Unit mode failuer diag» display
screen, select the {Clear Memory} and press the
[YES] key.
Display
Clear memory?
5) When the "Done" are shown on the display
screen, turn the ignition switch to OFF.
NOTE:
For detailed operation procedure, refer to "SUBA-
RU SELECT MONITOR OPERATION MANUAL".
8. FREEZE FRAME DATA
NOTE:
• Data stored at the time of trouble occurrence is
shown on display.
• Freeze frame data will be memorized maximum
to 20.
• If freeze frame data is not stored in memory cor-
rectly (caused by low power supply of body inte-
grated unit), DTC will be displayed with "?" on the
head of it in the Subaru Select Monitor display. This
shows it may be an unreliable reading.
Subaru Select Monitor
Contents to be monitored
Clear function of DTC and
freeze frame data
LAN(diag)-20