Subaru LEGACY 2004 Service Manual page 628

EXTERIOR BODY PANELS
4) Disconnect the connector of door harness from
body harness.
5) Put a wooden block on jack and place jack under
the front door. Support the door with a jack to pro-
tect it from damage.
6) Remove the bolt from the door checker.
7) Remove the door-side bolts for upper and lower
hinges to remove front door panel.
8) Remove the door hinge from vehicle.
Front Door
B: INSTALLATION
1. FRONT DOOR PANEL
Install in the reverse order of removal.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion".
<Ref. to EB-8, FRONT DOOR PANEL, COM-
PONENT, General Description.>
2. FRONT DOOR ASSEMBLY
1) Put a wooden block on jack and place the front
EB-00151
door on that.
2) Apply grease to the sliding area of door hinges,
and install the door hinge to vehicle.
EB-00013
3) Install the front door to upper hinge and lower
hinge adjusting by jack.
4) Tighten the bolt of door checker.
5) Connect the door harness connector, and install
the instrument panel lower cover.
6) Install the front pillar lower trim.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion".
<Ref. to EB-8, FRONT DOOR PANEL, COM-
PONENT, General Description.>
EB-00014
C: ADJUSTMENT
1) Using the ST, loosen the body-side bolts of up-
per and lower hinges to align the position of front
door panel longitudinally and laterally.
ST 925610000
EB-00015
EB-18
EB-00013
DOOR HINGE WRENCH
ST
EB-00016