Vehicle Equipment - Subaru LEGACY 2004 Service Manual

LAN SYSTEM (DIAGNOSTICS)
No. Data
11 Answer-back buzzer setup
12 Hazard answer-back setup
13 Automatic locking setup
14 Ans.-back Buzzer
15 Auto locking
16 Initial Keyless Setting
17 Initial button setting
18 Initial Security setting
19 Passive Alarm (Not used)
Door open warning
20 (prevention of battery run-
out)
(Specification) Security
21
setup
5) After setting, make sure that vehicle equipment is same as the setting changed in the {Current Data Dis-
play & Save}.
CAUTION:
• It is possible to control the original functions of vehicle when settings above are corresponded to

vehicle equipment.

• Do not change the settings except for setting above during operation of equipment setting.
• Be sure not to change "Factory" initial setting except in installation of new body integrated unit.
NOTE:
For details concerning operation procedure, refer to "SUBARU SELECT MONITOR OPERATION MANUAL".
Subaru Select Monitor
Initial
setting Customize setting
value
ON
ON
OFF
ON
ON
OFF
ON
ON
OFF
ON
ON
OFF
ON
ON
OFF
—
—
Execution
—
—
Execution
—
—
Execution
ON
OFF
OFF
ON
OFF
OFF
ON
OFF
OFF
LAN(diag)-22
Remarks
Workable when Answer-back buzzer setup is set to "ON"
When lock/unlock is selected by keyless entry system oper-
ated, answer-back buzzer sounds.
When lock/unlock is selected by keyless entry system oper-
ated, answer-back buzzer does not sound.
Workable when Hazard answer-back setup is set to "ON"
When lock/unlock is selected by keyless entry system oper-
ated, hazard answer-back operates.
When lock/unlock is selected by keyless entry system oper-
ated, hazard answer-back does not operate.
Workable when Automatic locking setup is set to "ON"
When lock/unlock is selected by keyless entry system oper-
ated, automatic locking operates.
When lock/unlock is selected by keyless entry system oper-
ated, automatic locking does not operate.
Vehicle is controlled in answer-back buzzer equipped mode.
Vehicle is controlled in answer-back buzzer non-equipped
mode. (Set Ans.-back Buzzer to "OFF" in model without
answer back buzzer.)
Vehicle is controlled in auto locking equipped mode.
Vehicle is controlled in auto locking non-equipped mode.
(Set Auto locking to "OFF" in model without answer-back
buzzer.)
Settings of keyless entry system are initialized. (No. 2: 30
sec., No.11: ON, No.12: ON, No.13: ON, No.14: ON)
Settings of each function are initialized. (No. 1: Normal, No.
3: 15 min., No. 4: 15 min., No. 8: ON)
Settings of security system are initialized. (No. 5: OFF, No.
6: OFF, No. 7: ON, No.10: OFF)
Applicable to North America model (If Passive Alarm is set
to "ON", nothing operates and there is no negative effect.)
If detecting door open for 30 minutes, room light, key illumi-
nation and door warning light are turned off to prevent bat-
tery run-out.
Room light, key illumination and door warning light is not
turned off.
Selected security settings in active condition (EK model)
Normally in active condition
—
—
—