Maintenance Overview - Toshiba Magnia Z310 User Manual

Connecting Hardware Devices

Maintenance Overview

WARNING: Never disassemble the server more than described in this manual.
Failure to observe this precaution could result in electric shock, cause a system
failure, or void your warranty.
When performing maintenance on the server, follow these general steps:
1 Carefully read the precautions mentioned previously in this chapter. See
Optional Hardware Devices
2 If the server is running, shut down the operating system, turn off all the peripheral
devices connected to the server, then press and hold the Power button to turn off the
server.
3 Unplug the power cable from the AC outlet or UPS, then disconnect all signal cables
connected to the I/O connectors on the back of the server.
4 Remove the outer cover and the server panels. See
server panels
5 Perform the required maintenance.
CAUTION: Make sure that components handled during system maintenance are
properly installed and connections are securely seated. Also check that no tools or
hardware items are left inside the server.
6 Reinstall the server's access cover. See
on page 39.
7 Reconnect all signal cables.
8 Press the Power button to turn on the server, then run any required system checks.
NOTE: Some optional devices require you to reconfigure the server's software,
change jumper, and/or DIP switch settings before the device can be used.
on page 75.
on page 39.
Removing and replacing the
Removing and replacing the server panels
77
Maintenance Overview
Connecting